Nissan Code P1740 is a problem that can occur in Nissan vehicles, caused by a cut line, short, or similar issue. The issue can be recognized by the Transmission Control Module (TCM) as irregular, as it compares a target value with a monitor value. The cause of this problem can be attributed to a few reasons, such as a faulty harness or connectors in the solenoid circuit, or an issue with the Lock-up select solenoid valve. In this article, we will look at the causes and solutions of Nissan Code P1740.
Causes and Solutions of Nissan Code P1740
| Cause | Solution |
|---|---|
| Faulty Harness or Connectors | Check wiring and connections for any damage or loose terminals |
| Lock-up Select Solenoid Valve | Replace the valve or clean it if it is dirty |
| Cut Line, Short | Check the wiring and connections for any signs of damage |
| Transmission Control Module (TCM) | Replace the TCM if it is not working properly |
Faulty Harness or Connectors
If there is a faulty harness or connectors in the solenoid circuit, then the Nissan Code P1740 can be triggered. To identify the issue, you will need to check the wiring and connections for any damage or loose terminals. If any of the connections are loose, they should be tightened and secured properly. If any of the wires are damaged, they should be replaced.
Lock-up Select Solenoid Valve
The Lock-up Select Solenoid Valve can become faulty and cause the Nissan Code P1740 to be triggered. To fix this issue, you will need to replace the valve or clean it if it is dirty. If the valve is dirty, it should be cleaned with a solvent and then re-installed.
Cut Line, Short
A cut line, short, or similar issue can cause the Nissan Code P1740 to be triggered. To identify the issue, you will need to check the wiring and connections for any signs of damage. If there is any damage, the wires should be replaced and the connections should be tightened.
Transmission Control Module (TCM)
The Transmission Control Module (TCM) can become faulty and cause the Nissan Code P1740 to be triggered. To fix this issue, you will need to replace the TCM if it is not working properly. If the TCM is faulty, it should be replaced with a new one.
Conclusion
In conclusion, Nissan Code P1740 can be attributed to a few causes, such as a faulty harness or connectors in the solenoid circuit, or an issue with the Lock-up select solenoid valve. To fix the issue, you will need to check the wiring and connections, replace the valve, or replace the TCM. Proper diagnosis and repairs of Nissan Code P1740 should be done in order to ensure that the problem is fixed properly.
https://www.youtube.com/watch?v=UWZNzIdLT2I
Was this page helpful?