- Replace the front impact sensor.
- Reprogram the SDM.
- Check the wiring.
- Check the ground connection.
The HUMMER Code B0103 is an electronic right front impact sensor that has specific ignition voltage requirements of 9-16 volts. This code is generated when the B0100 and B0103 messages are not received within 5 seconds of the sensor being powered up, or when the status message is not received. Additionally, if the SDM fails twice to reset the front impact sensor, the code is generated. To resolve this issue, it is important to replace the front impact sensor, reprogram the SDM, check the wiring, and check the ground connection. With the right combination of solutions, the HUMMER Code B0103 can be resolved efficiently and safely.
Causes and Solutions for the HUMMER Code B0103
| Cause | Solution |
|---|---|
| B0100 and B0103 message not received within 5 seconds of the sensor being powered up. | Replace the front impact sensor. |
| Status message is not received. | Reprogram the SDM. |
| The SDM has failed twice to reset the front impact sensor. | Check the wiring and ground connection. |
| Ignition voltage is not between 9-16 volts. | Check electrical components. |
Replace the Front Impact Sensor
The front impact sensor should be replaced if the B0100 and B0103 messages are not received within 5 seconds of the sensor being powered up. This is a critical step as the sensor is responsible for controlling the airbag and other safety-related functions. It is important to ensure that the sensor is functioning properly before continuing with any other procedures.
Reprogram the SDM
If the status message is not received, it is important to reprogram the SDM, or Sensing Diagnostic Module. This is an important step to ensure that the SDM is operating correctly and is able to communicate properly with the front impact sensor.
Check the Wiring and Ground Connection
If the SDM has failed twice to reset the front impact sensor, it is important to check the wiring and ground connection. This is to ensure that all the electrical components are connected properly and that all the connections are in good condition.
Check Electrical Components
Finally, if the ignition voltage is not between 9-16 volts, it is important to check the electrical components. This is to ensure that the electrical system is functioning properly and that there are no underlying issues that could be causing the issue.
Conclusion
In conclusion, the HUMMER Code B0103 is generated when certain conditions are met. It is important to replace the front impact sensor, reprogram the SDM, check the wiring and ground connection, and check the electrical components in order to resolve the issue. With the right combination of solutions, the HUMMER Code B0103 can be resolved efficiently and safely.
https://www.youtube.com/watch?v=bl036XpdW94
Was this page helpful?