Have you ever been driving your Mazda and encountered a problem with the engine speed signal circuit, with the dreaded code P0725? This code indicates that the Powertrain Control Module (PCM) has detected the Engine Speed signal indicating less than 300 rpm for more than 10 seconds during the Cruise Control Module (CCM) rationality test. This Mazda Code P0725 can be caused by several different issues, including an erratic or missing CMP sensor signal (an intermittent fault), a PCM to TCM circuit that is open or shorted to ground, a failed TCM, or a failed PCM. Below is a table of the causes and potential solutions for this issue.
Mazda Code P0725 Causes and Solutions
| Cause | Solution |
|---|---|
| CMP sensor signal erratic or missing | Replace the CMP sensor |
| PCM to TCM circuit is open or shorted to ground | Check the wiring for any faults |
| TCM has failed | Replace the TCM |
| PCM has failed | Replace the PCM |
The Problem of CMP Sensor Signals
When it comes to the Mazda Code P0725, the most common issue is that the CMP sensor signals are either erratic or missing. In this case, you will need to replace the CMP sensor in order to get your vehicle back running smoothly. However, before you do this, you should check the wiring for any faults, as this could also be a cause of the problem.
PCM to TCM Circuit Issues
Another common cause of the Mazda Code P0725 is that the PCM to TCM circuit is open or shorted to ground. This could be due to a faulty wiring connection, or a failed component in the circuit. If this is the case, you should check the wiring for any faults and ensure that all connections are secure and functioning properly.
Faulty TCM or PCM
Finally, the Mazda Code P0725 could also be caused by a faulty TCM or PCM. If this is the case, then you will need to replace the faulty component in order to get the vehicle back running smoothly.
Conclusion
In conclusion, the Mazda Code P0725 can be caused by several different issues, including an erratic or missing CMP sensor signal, a PCM to TCM circuit that is open or shorted to ground, a failed TCM, or a failed PCM. It is important to identify the cause of the Mazda Code P0725 in order to find the right solution and get your vehicle back on the road.
https://www.youtube.com/watch?v=xglSS3SuNeA
Was this page helpful?