Jeep owners everywhere should be aware of the Jeep Code P0349. It describes a Camshaft Position (CMP) Sensor that detects changes in the magnetic field. Several factors, including engine oil level, engine oil aeration, incorrect engine oil filter, and insufficient oil pressure, can cause these changes. The PCM decodes the tooth pattern to identify the camshaft position, which is used to sequence the engine’s ignition timing and fuel injection events. If the CMP Sensor is faulty or fails, a DTC is set, and the MIL will illuminate. The cause of the Jeep Code P0349 can range from low engine oil level to the PCM itself. This article will discuss the causes and solutions for the Jeep Code P0349.
💥See also: Jeep Code P2121
Causes and Solutions for Jeep Code P0349
| Causes | Solutions |
|---|---|
| Low Engine Oil Level | Check engine oil level and refill as necessary |
| Engine Oil Aerated or Contaminated | Replace engine oil and filter |
| Incorrect Engine Oil Filter | Replace the engine oil filter with the correct type |
| Insufficient Oil Pressure Due to a Mechanical Failure in the Oiling System | Replace any damaged components in the oiling system and check for proper oil pressure |
Low Engine Oil Level
When the engine oil level is too low, it can cause an incorrect signal to be sent from the CMP Sensor to the PCM, resulting in a Jeep Code P0349. Owners should check their engine oil level and refill as necessary. It is also important to use the correct engine type and amount of oil.
Engine Oil Aerated or Contaminated
Engine oil that is aerated or contaminated can also cause the Jeep Code P0349. In this case, owners should replace the engine oil and filter. It is important to use the correct type of oil and filter for the engine.
🎯Suggested article: Jeep Code P0013
Incorrect Engine Oil Filter
An incorrect engine oil filter can also lead to the Jeep Code P0349. In this case, owners should replace the engine oil filter with the correct type. It is important to use the right type of filter for the engine.
Insufficient Oil Pressure Due to a Mechanical Failure in the Oiling System
If there is a mechanical failure in the oiling system, the oil pressure may be too low. This can cause the Jeep Code P0349. In this case, owners should replace any damaged components in the oiling system and check for proper oil pressure.
💥See also: Jeep Code C2200
Conclusion: Solving Jeep Code P0349
Jeep owners should know the Jeep Code P0349 and its potential causes. Low engine oil level, engine oil aeration or contamination, incorrect engine oil filter, and insufficient oil pressure due to a mechanical failure in the oiling system can all cause the Jeep Code P0349. If owners face this code, they should check the engine oil level, replace the engine oil and filter, replace the engine oil filter with the correct type, and replace any damaged components in the oiling system. Owners can easily troubleshoot and fix the Jeep Code P0349 by following these steps. Jeep Code P0349 can be resolved easily and quickly with the right troubleshooting steps.
👀Look at this: Jeep Code U0401
Was this page helpful?