Ford’s Code P061B, or Internal Control Module Torque Calculation Performance, is a diagnostic trouble code that sets when a calculation error occurs in a vehicle’s Powertrain Control Module (PCM). This code is associated with a number of potential causes and potential solutions. Common causes of this code include aftermarket performance products, PCM programming errors, and sensor and circuit-related diagnostic trouble codes. Diagnosis of this issue typically involves checking for sensor and circuit related DTCs, reprogramming or updating the calibration, and checking for other DTCs or drive symptoms for further action. A number of related service bulletins are available, such as 11-10-21, 11-8-5, 12N03, 13-9-19, 15-0074, 15-0118, 17-0014, 18-2321, 19-2091, SSM47363, SSM47680, SSM50354 and SSM50381.
🎯Suggested article: Ford Code U0100:87
Causes and Solutions for Ford Code P061B
| Cause | Solution |
|---|---|
| Aftermarket performance products | Check for sensor and circuit-related DTCs, reprogram or update the calibration, and check for other DTCs or drive symptoms for further action. |
| PCM programming error | Make sure to check for aftermarket performance products before installing a new PCM. |
| Sensor and circuit-related DTCs | Check for sensor and circuit-related DTCs, reprogram or update the calibration, and check for other DTCs or drive symptoms for further action. |
| Other DTCs or drive symptoms | Check for sensor and circuit-related DTCs, reprogram or update the calibration, and check for other DTCs or drive symptoms for further action. |
Aftermarket Performance Products
When it comes to diagnosing Ford Code P061B, it is essential to check for aftermarket performance products that could be causing the issue. If aftermarket products are discovered, the PCM will need to be programmed differently to accommodate the new parts. This can be done by reprogramming or updating the calibration.
⚡️Other article: Ford Code P1298
PCM Programming Error
A PCM programming error can also cause Ford Code P061B to set. Before installing a new PCM, it is essential to ensure that any aftermarket performance products are considered. The same issue may occur if the PCM is not programmed to account for these parts.
In some cases, Ford Code P061B may be caused by a sensor or circuit-related DTC. To diagnose the issue, a technician will need to check for any sensor and circuit-related DTCs and then reprogram or update the calibration. Additionally, they should check for other DTCs or drive symptoms that might provide more insight into the cause of the issue.
📢Read also: Ford Code P0390
A number of related service bulletins are available for Ford Code P061B, such as 11-10-21, 11-8-5, 12N03, 13-9-19, 15-0074, 15-0118, 17-0014, 18-2321, 19-2091, SSM47363, SSM47680, SSM50354, and SSM50381. These bulletins provide detailed information on diagnosing and fixing the issue.
🚀Recommended article: Ford Code P0112
Conclusion
Ford Code P061B is a diagnostic code that sets when a calculation error occurs in a vehicle’s Powertrain Control Module (PCM). This code is associated with a number of potential causes and potential solutions, such as aftermarket performance products, PCM programming errors, and sensor and circuit-related diagnostic trouble codes. To diagnose the issue, technicians should check for related DTCs and then reprogram or update the calibration. Ford’s service bulletins can also provide detailed information on diagnosing and fixing the issue for Ford Code P061B.
Was this page helpful?