Regarding Volvo vehicles, there is a common problem that can arise with the ECM-9700 code. Volvo Code ECM-9700 is related to the Accelerator Pedal (AP) Position Sensor, which provides a digital signal to the engine control module (ECM). When this signal deviates from the predefined values, a diagnostic trouble code (DTC) is stored in the ECM. Many Volvo owners have experienced this issue, and it is important to understand the causes and solutions to this problem. Below is a table that outlines the various reasons and solutions to the ECM-9700 code.
💥See also: Volvo Code ECM-P017100
Causes and Solutions for the ECM-9700 Code
| Cause | Solution |
|---|---|
| Contact resistance or oxidation in the terminals between the engine control module (ECM) and the accelerator pedal (AP) position sensor | Use a multimeter to check the terminals for resistance and clean them with a wire brush if necessary. |
| Open-circuit or short-circuit to ground or supply voltage in the signal cable | Replace the signal cable and check the ECM for any faults. |
| Damaged accelerator pedal (AP) position sensor | Replace the accelerator pedal (AP) position sensor. |
| Faulty Signal | Check the ECM for any faults and reset the code. |
Cause 1: Contact Resistance or Oxidation in the Terminals Between the Engine Control Module (ECM) and the Accelerator Pedal (AP) Position Sensor
The ECM-9700 code can be caused by contact resistance or oxidation in the terminals between the engine control module (ECM) and the accelerator pedal (AP) position sensor. This can lead to the ECM not receiving the correct signal from the AP position sensor. To check for any contact resistance or oxidation, a multimeter should be used to measure the terminals. If there is any resistance, the terminals can be cleaned with a wire brush.
Cause 2: Open-Circuit or Short-Circuit to Ground or Supply Voltage in the Signal Cable
An open-circuit or short-circuit to ground or supply voltage in the signal cable can also cause the ECM-9700 code. This can lead to the ECM not receiving the correct signal from the AP position sensor. To resolve this issue, the signal cable should be replaced, and the ECM should be checked for any faults.
💥See also: Volvo Code ECM-P035400
Cause 3: Damaged Accelerator Pedal (AP) Position Sensor
A damaged accelerator pedal (AP) position sensor can also cause the ECM-9700 code. This can lead to the ECM not receiving the correct signal from the AP position sensor. To resolve this issue, the accelerator pedal (AP) position sensor should be replaced.
Cause 4: Faulty Signal
A faulty signal from the AP position sensor can also cause the ECM-9700 code. This can lead to the ECM not receiving the correct signal from the AP position sensor. To resolve this issue, the ECM should be checked for any faults, and the code should be reset.
Conclusion: Get the Volvo Code ECM-9700 Problem Fixed ASAP
The Volvo Code ECM-9700 code is a common problem experienced by many Volvo owners. It is important to understand the causes and solutions to this problem to get it fixed as soon as possible. The causes of this code can range from contact resistance or oxidation in the terminals to open-circuit or short-circuit to ground or supply voltage in the signal cable, to a damaged Accelerator Pedal (AP) position sensor, or a faulty signal. By understanding the causes and solutions for the Volvo Code ECM-9700 code, Volvo owners can take the necessary steps to get their vehicles fixed and back on the road.
Was this page helpful?