The MINI code P1613 indicates an ASC error that happens when the engine is started, the Vehicle Speed Sensor (VSS) is over 1 mph, and the Digital Motor Electronics (DME) detects a problem within the Automatic Stability Control (ASC) system during the self-test. This issue can be caused by an open or short circuit to
When it comes to BMW vehicles, code P1339 is a common issue that affects the camshaft position sensor. This code is triggered when the engine starts, the battery voltage is at least 11.5 volts, all electrical components are off, and the DME detects an unexpected low or high voltage condition on the camshaft position sensor
Jeep Code B1B02 is a diagnostic trouble code related to the driver airbag squib 1 circuit open. This code is typically associated with the Occupant Restraint Controller (ORC) which monitors the resistance of the Driver Squib 1 circuits. If the ORC detects an open or high resistance on the Driver Squib 1 circuits, this code
Hyundai Code B1448 is an error code that indicates a Passenger Occupant Detecting System (PODS) Circuit Fault. This code typically arises due to poor connection of connected parts, a faulty Occupant Classification (OC) Sensor, or a faulty Side Restraint System Control Module (SRSCM). As these issues can be complex to diagnose and repair, it is
The Hyundai Code P2159 is an issue with the Vehicle Speed Sensor “B” Range/Performance. If the vehicle speed signal is not 1.0 Km/h or higher for at least two seconds when the conditions are enabled, the ECM sets the P2159 code. Understanding the causes of this issue is the first step to troubleshooting and fixing
Toyota Code P0402 is a diagnostic trouble code that is linked to the Excessive EGR Flow Detected. This code is triggered when the engine is started cold (ECT sensor signal less than 86ºF), the engine running without load at less than 4000 rpm, and the PCM detects the EGR sensor indicated a high value during
Signal Amplitude < MinimumThis sub type is used for failures where the control module measures a signal voltage below a specified range but not necessarily a short to ground (e.g., gain too low). The Toyota Code B1422/22 is a diagnostic code that is used to identify a malfunction in the A/C compressor, drive belt, harness
The Ford Code P0743 is a DTC that can be set in the PCM when the Torque Converter Clutch Solenoid Circuit Electrical has a fault. This can be due to a wide range of causes, including an open circuit, a shorted circuit, a damaged wiring harness connector, a damaged or failed TCC solenoid, or even
When a Dodge vehicle experiences issues with code P0202, it’s important to understand what is causing the problem and how to fix it. This code indicates a Fuel Injector 2 Circuit/Open issue, and the Powertrain Control Module (PCM) is responsible for controlling the operation of the injectors. The PCM determines the amount of fuel to
When it comes to diagnosing and fixing a Ford Code P1550, it is important to understand the potential causes and solutions so that the problem can be addressed quickly and correctly. This code, which is also known as the Power Steering Pressure Switch Circuit Malfunction, is triggered when the Key On Engine Running (KOER) Self-Test
When you encounter a Ford Code U0253:00, it can be a sign that a vehicle has lost communication with the Accessory Protocol Interface Module (APIM). This code is triggered when any of the APIM messages are missing, which can be due to a variety of causes such as an APIM failure, a circuit failure on